Resync a NAS Cluster

If you need to resync all nodes within a NAS cluster, which may be required if Quantum Service configures a new registry setting for the cluster, follow the steps outlined below.

Note: For a list of all the Appliance Controller commands, see the Command Index.

To resync a NAS cluster:

  1. Log in to the Appliance Controller CLI on the master node:
  2. Enter:

    3. nascluster resync

    > nascluster resync

     

    NAS Cluster applying Reset to resync NAS cluster settings ...

    Updating system NAS cluster configuration ...

    Check for master takeover ...

    Publish master configuration ...

    Waiting for nascluster_node_config_sync to complete on node 10.65.190.xxx

    [10.65.xxx.xxx]:

    Sending local auth-config sync to 10.65.190.194 ...

    [10.65.xxx.xxx]:

    [10.65.xxx.xxx]:

    [10.65.xxx.xxx]: Updating system NAS cluster configuration ...

    [10.65.xxx.xxx]: Verifying local configuration with master 10.65.186.20 ...

    [10.65.xxx.xxx]: Cluster verification for 10.65.190.194 in-progress ...

    [10.65.xxx.xxx]: Node state: pnn:1 10.65.190.194 OK (THIS NODE)

    [10.65.xxx.xxx]: Cluster verification of 10.65.190.194 successful ...

    Broadcasting share config-sync to NAS cluster ...

    Waiting for nascluster_share_config_sync to complete on node 10.65.xxx.xxx

    [10.65.xxx.xxx]:

    Cluster verification for 10.65.xxx.xx in-progress ...

    Node state: pnn:0 10.65.xxx.xx OK (THIS NODE)

    Cluster verification of 10.65.xxx.xx successful ...

    Successfully resynced NAS cluster configuration