Reports > Hardware Status

Note: At any time, you can click Refresh to manually update the report data.

1. On the Reports menu, click Hardware Status. The Hardware Status Report appears. The first tab, System Board, displays the following information about the system board in both nodes:

   Parameter	Description
   Component	The name of the component on the system board, such as the CMOS battery, IPMI, fans, and so on.
   Type	Indicates the category for the component, such as Alarm for the CMOS battery.
   Value	If applicable, indicates the current value for the component, such as “27 degrees” for the Ambient Temperature.
   Status	Indicates the current state of the component, such as Normal.

2. When you are finished viewing system board information, click the Network Ports tab. The Network Ports page tab displays the following information related to the network ports on both nodes:

   Parameter	Description
   Component	The name of the port component, such as eth1 for Ethernet port 1.
   Value	Indicates the correct value for the component, such as 1000 Mb/s for the Ethernet port.
   Status	Indicates the current state of the component, such as Up or Down.

3. When you are finished viewing network ports information, click the Fibre Channel Ports tab. The Fibre Channel Ports page appears. The Fibre Channel Ports tab displays the following information related to the fibre channel ports on both nodes:

   • Node name and status

   • Unit name, location, port number and status

   • Port name and status

4. When you are finished viewing fibre channel port information, click the Storage Arrays tab. The Storage Arrays page displays the following about your storage array:

   Parameter	Description
   Source	The array node or cluster.
   Array	The name of the array.
   Type	The array manufacturer.
   Status	Indicates the current state of the component, such as Attention or Normal.
   Component Group	The array component category, such as trays, controllers, volumes, drives, alarms and so on.
   Count	The current number of each component group in the array (for example, “2 Volumes”).
   Status	The current operational status of the component group, such as Normal. Information for the following headings appears after you select a component group.
   Component	The name or location indicator of the selected component group (such as “SAS Phy 1”).
   Location	The current location of the selected component group.
   Value	The current value of the selected component group, such as Up or Down.
   Status	The current operation status of the selected component group, such as Normal.